There’s no doubt that installing wooden flooring not only gives warmth, style and depth, but it will also add value to your home. Moreover, to get the most from your wooden floors, in terms of benefits and value, it’s important to do it the right way.
Preparation is most important
Fully preparing the area is crucial, and you need to make sure the surface is clean, smooth, level, dry and structurally sound. It’s possible to lay hardwood on existing floors if they’re in good condition, as well as concrete bases or a new plywood sub base. Be sure to remove any doors and skirting's, moldings or floor trims, so you can lay the floor right to the edge of the room, but leaving an expansion gap. It’s also a good idea to let the wood adjust to your homes temperature and humidity before you start laying. You’ll also need a good quality underlay across the entire area, if you are going to float the floor, with regard to nailing see laying the first row section, which is the same for floating and nailing, except you substitute glue for nails.
Accurate Measurements MUST BE DONE
Make sure you measure the room accurately and ideally establish where the floor joists run, as you want to lay your floor perpendicular to them, if you are going to fix to them. Also establish the longest straight wall and use that as your guideline for floor alignment.
Lay your floor in a staggered formation, whether you do this with different lengths of wood. It’s also a nice design touch, to mix up different wood cuts for variation in wood colour and grains.
Laying the First Board
Facing the tongue of the first board away from the wall, dry-fit the first board using 10 mm spacers between the board and the wall and then nail it into the sub floor using a 500 mm nail about 70 mm from the end, and every 3000 mm on the grooved edge and continue fitting the rest of the first row as above. From the second row onward, you’ll need to use a tapping block to snugly fit the tongue and groove, then blind-nail through the tongue 70-100 mm from the end and every 300 mm along the board, if you are laying solid floors, fixed to a timber substrate.
The Final Nudge
The tricky part comes with finishing your floor, the last row is tough to nail in, so use a crowbar to push them tightly together whilst you nail them down. You can also stick smaller pieces with glue in tight corners. Once you have the final pieces fitted it’s time to trim any exposed underlay, re-attach your skirting boards, molds and doors, as well as transition strips between rooms and use wood filler to cover any nail holes. If your hardwood floor hasn’t already been sanded and varnished, you’ll need to do this before it’s finished and allow plenty of drying time.
Wood flooring is a great way to create a wonderful finish and style to your home, so take our advice and you won’t go far wrong. Here at Tomson Floors, we’ve been working with hardwood floors for years and we’re here to impart some of our expertise and wisdom, so that when it comes to installing your hardwood flooring, it’s always done correctly.
Visit our Glasgow and Edinburgh wood flooring showrooms to view full flooring collection or if you looking for installation services.
Wood Flooring With Style
Browse by Construction:
Solid Wood Flooring
Engineered Wood Flooring
Wood Flooring Accessories
Composite Wood Decking
Comosite Wood Fencing